Chip for Carrera D132 Digital system
* Small (25x15 mm) in-car chip for Carrera Digital D132
* Comes with standard Slot.it connectors for most Slot.it models released from April 2020 and Scalextric/Pioneer models fitted Scalextric SSD socket
* External infrared LED on wires may be used (available separately). Please note this is required for some models for example F1 chassis etc.
NOTE: The safety car function is not possible with this chip. Ghost function does work.
SP43 ASSEMBLY INSTRUCTIONS
Mounting procedure for any slot car equipped with Slot.it quick-connectors:
1. Loosen chassis screws, take off chassis
2. Connect end A to the front brushes quick-connector
3. Connect end B to the motor quick-connector
4. Proceed to programming according to normal Carrera guidelines
Mounting procedure for any slot car equipped with Scalextric 4-PIN connector (DPR model):
1. Loosen chassis screws, take off chassis
2. Loosen bottom hatch screw, disconnect 4-PIN connector
3. If Slot.it replacement hatch is used, securely fix the chip to it with the 2 clamps. Make sure the infrared LED is visible from the bottom hole
4. Connect the chip with the 4-PIN connector through the dedicated port
5. Proceed to programming according to normal Carrera guidelines
Note: If car has inverted polarity (car runs the wrong way), use inverter cable (CODE: SP46), inserted between chip and motor
Slot.it also offer a Bay Lid for DPR models - code O201C-S04
For other cars hobbyist skills are required to install the chip without the connectors, including soldering.
The cable with connectors is available separately (part SP45) for cars without the connectors.
Video from Slot.it for installation into Slot.it, Policar and Scalextric DPR and Pioneer models.
https://youtu.be/V9t40oFarDc
